>>boot 6/tftp console=ttyS3 root=/dev/sda1
2224128+0+172576
This DECstation is a DS5000/200
CPU revision is: 00000220
FPU revision is: 00000320
Primary instruction cache 64kb, linesize 4 bytes
Primary data cache 64kb, linesize 4 bytes
Linux version 2.4.16 (root@elrond) (gcc version 2.96 20000731 (Red Hat Linux 7.1 2.96-96.1)) #6 Fri Dec 21 16:59:26 MET 2001
Determined physical RAM map:
 memory: 06000000 @ 00000000 (usable)
On node 0 totalpages: 24576
zone(0): 24576 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: console=ttyS3 root=/dev/sda1
Calibrating delay loop... 24.87 BogoMIPS
Memory: 94160k/98304k available (2007k kernel code, 4144k reserved, 87k data, 76k init)
Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode-cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount-cache hash table entries: 2048 (order: 2, 16384 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
Checking for 'wait' instruction...  unavailable.
POSIX conformance testing by UNIFIX
TURBOchannel rev. 1 at 25.0 MHz (without parity)
    slot 5: DEC      PMAZ-AA  V5.3b
    slot 6: DEC      PMAD-AA  V5.3a
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
devfs: v0.120 (20011103) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
LK201 Support for DS5000/200 not yet ready ...
pty: 256 Unix98 ptys configured
DECstation DZ serial driver version 1.02
ttyS00 at 0xbfe00000 (irq = 4)
ttyS01 at 0xbfe00000 (irq = 4)
devfs: devfs_register(): device already registered: "ttyS"
devfs: devfs_register(): device already registered: "cua"
ttyS02 at 0xbfe00000 (irq = 4)
devfs: devfs_register(): device already registered: "ttyS"
devfs: devfs_register(): device already registered: "cua"
ttyS03 at 0xbfe00000 (irq = 4)
devfs: devfs_register(): device already registered: "ttyS"
devfs: devfs_register(): device already registered: "cua"
rtc: Digital DECstation epoch (2000) detected
Real Time Clock Driver v1.10e
block: 128 slots per queue, batch=32
declance.c: v0.008 by Linux Mips DECstation task force
eth0: PMAD-AA, addr = 08:00:2b:1a:97:2c, irq = 3
SCSI subsystem driver Revision: 1.00
SCSI ID 7 Clk 25MHz CCF=5 TOut 167 NCR53C9x(esp236)
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : ESP236 (NCR53C9x)
  Vendor: COMPAQ    Model: C2490A            Rev: 5193
  Type:   Direct-Access                      ANSI SCSI revision: 02
Attached scsi disk sda at scsi0, channel 0, id 3, lun 0
esp0: target 3 [period 200ns offset 8 5.00MHz synchronous SCSI]
SCSI device sda: 4110000 512-byte hdwr sectors (2104 MB)
Partition check:
 /dev/scsi/host0/bus0/target3/lun0: p1 p2
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused PROM memory: 252k freed
Freeing unused kernel memory: 76k freed
INIT: version 2.78 booting
                        Welcome to Red Hat Linux
                Press 'I' to enter interactive startup.
Mounting proc filesystem:  [  OK  ]
Configuring kernel parameters:  [  OK  ]
Setting clock  (utc): Sun Dec 23 15:39:18 MET 2001 [  OK  ]
Activating swap partitions:  [  OK  ]
Setting hostname elros:  [  OK  ]
Checking root filesystem
/: clean, 42499/240480 files, 113172/480066 blocks
[/sbin/fsck.ext2 -- /] fsck.ext2 -a /dev/sda1
[  OK  ]
Remounting root filesystem in read-write mode:  [  OK  ]
Finding module dependencies:  [  OK  ]
Checking filesystems
Checking all file systems.
[  OK  ]
Mounting local filesystems:  [  OK  ]
Enabling swap space:  [  OK  ]
INIT: Entering runlevel: 3
Entering non-interactive startup
Setting network parameters:  [  OK  ]
Bringing up interface lo:  [  OK  ]
Bringing up interface eth0:  [  OK  ]
Starting system logger: [  OK  ]
Starting kernel logger: [  OK  ]
Starting portmapper: [  OK  ]
Starting keytable:  [  OK  ]
Initializing random number generator:  [  OK  ]
Mounting other filesystems:  [  OK  ]
Synchronizing with time server: [  OK  ]
Starting ntpd: [  OK  ]
Starting xinetd: [  OK  ]
Starting crond: [  OK  ]


Red Hat Linux release 7.1 (Seawolf)
Kernel 2.4.16 on a mips

elros login: